Makita DMR300 Manuel D'instructions page 11

CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.6: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
(For LXT battery only)
(For LXT battery only)
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Using the soft bended rod antenna
When listening to FM radio stations, straight up the soft
bended rod antenna as shown in the figure.
► Fig.7: 1. Soft bended rod antenna
NOTICE:
Always store the soft bended rod antenna
to the original position after use.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Using Supplied AC power adaptor
WARNING:
adaptor completely before moving the radio. If the
AC power adaptor is not removed, it may cause
an electric shock.
WARNING:
of the AC power adaptor. If not, the radio may
accidentally fall down, causing injury to you or
someone around you.
WARNING:
the means of connecting the radio to the mains
supply. The mains socket used for the radio must
remain accessible during normal use.
WARNING:
the AC power adaptor should be removed from
the mains outlet completely
WARNING:
plied with the product or specified by Makita only.
WARNING:
cable and plug by your mouth. Doing so might
cause an electric shock.
WARNING:
greasy hand.
WARNING:
increase the risk of electric shock. If the cord
is damaged, have it replaced by our authorized
service center in order to avoid a safety hazard.
Do not use it before repair.
WARNING:
adaptor out of the reach of children.
Open the cover and insert the adaptor plug into the DC
IN socket on the side of the radio. Plug the adaptor into
a standard mains socket outlet. While the radio is pow-
ered from AC power adaptor, the indicator for AC power
supply ( ) will appear on the display.
► Fig.8: 1. Cover 2. DC IN socket 3. Adaptor plug
NOTE: When the adaptor is used, the radio is pow-
ered from the mains and the battery cartridge is
charged.
NOTE: When the radio has any interference in AM
band by its AC adaptor, move the radio away from the
AC adaptor further than 30 cm (1 feet).
Auxiliary input socket
► Fig.9: 1. AUX IN 1 2. AUX IN 2
Two 3.5 mm stereo auxiliary input sockets are provided.
One is at the front of the radio (AUX IN 1); the other is
located in the battery compartment (AUX IN 2).
1. Connect an external audio source, such as a MP3
or CD player, to the auxiliary input socket.
2. Repeatedly press and release the Source but-
ton until AUX IN 1 or 2 is displayed.
3.
Adjust the volume setting on your external audio
source to ensure an adequate signal level. After that,
use the Tuning control knob
for comfortable listening.
11 ENGLISH
Always disconnect the AC power
Never pull and/or drag the cord
The AC power adaptor is used as
In order to disconnect the radio,
Use the AC power adaptor sup-
Do not hold the power supply
Do not handle the plug with wet or
Damaged or entangled cords
After use, always store AC power
on the radio as needed