Nolan N808 Instructions D'utilisation page 22

N80-8
enables the position of the liner to be adjusted. This means that, unlike a standard
helmet, the position of the helmet on the rider's head can be changed without changing
the size of the helmet, making it adaptable to multiple needs.
To adjust the liner, deactivate the VPS, open the chin strap (see relevant instructions)
and proceed as follows.
1.1 Overturn one side of the upper part of the padding and unhook the front circular
button for adjusting the liner below it from the underlying longitudinal plastic sup-
port with seven holes (Fig. 18).
1.2 Move the circular button along the longitudinal plastic support and re-hook it in
one of the two following holes (Fig. 19).
1.3 Repeat the process of points 1.1 and 1.2 with the rear circular button located
below the padding (Fig. 20).
By pulling the two adjustment snaps of the liner, the helmet is gradually posi-
tioned higher on the head.
1.4 After having correctly fastened the two adjustment snaps of the liner to the longi-
tudinal plastic support, fold and spread the upper padding in the correct position.
1.5 Wear the helmet and ensure that the positioning and comfort suit your head. If it is
not, adjust it again.
WARNING
After adjusting the position of the liner, put on and fasten the helmet to check the cor-
rect adjustment of the chin strap (see attached label). Check also the correct helmet
fit on your head in riding position setup, as well as its easy taking off - please refer to
"CHOICE AND VERIFICATION OF THE HELMET" instructions above.
EYEWEAR ADAPTIVE
1 CREATING SPACE FOR THE EYEWEAR
1.1 Remove the left cheek pad from the helmet (see instructions above).
1.2 Remove the inner expanding foam cheek padding (see instructions above).
1.3 Detach the upper part of the pre-punched inner padding (Fig. 21), then correctly
reposition the remaining part of the padding in the cheek pad.
It is recommended that you keep the removed padding for reuse in the future
1.4 Refit the inner expanding foam cheek padding of the cheek pad (see instructions above).
1.5 Refit the full cheek pad on the helmet (see instructions above).
1.6 Repeat these steps with the padding of the right cheek pad.
2 CLOSING SPACE FOR THE EYEWEAR
2.1 Remove the left cheek pad from the helmet (see instructions above).
2.2 Remove the inner expanding foam cheek padding (see instructions above).
2.3 Properly insert part of the previously removed padding into the fabric lining cover
of the cheek pad (Fig.21).
2.4 Refit the full cheek pad on the helmet (see instructions above).
2.5 Repeat these steps with the padding of the right cheek pad.
NOLAN EMERGENCY RELEASE SYSTEM ( NERS )
The Nolan Emergency Release System (NERS) allows the rescue personnel to remove
the paddings of the cheek pads from the helmet while it is still on the rider's head.
22
INSTRUCTIONS FOR USE