Nolan N808 Instructions D'utilisation page 20

N80-8
1.2 Gently pull the red strap in the front area of the left cheek pad to release the safety
lever placed on the back (Fig. 10).
1.3 Grasp the front part of the left cheek pad and turn it upwards to unhook the front
hook and the upper snap fastener, placed on the back (Fig. 11).
1.4 Pull the back of the left cheek pad towards the inside of the helmet to release the
rear snap fastener placed on the back (Fig.12).
1.5 Remove the rear tab of the comfort padding of the left cheek pad from the cavity
between the rear seal and the polystyrene inner shell; then completely remove the
cheek padding from the helmet (Fig.13).
1.6 Repeat these steps with the padding of the right cheek pad.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after disassembling the cheek
pads from the helmet (see instructions above).
2.1 Gently remove the inner expanded foam padding from the fabric lining cover of the
left cheek pad (Fig.14).
2.2 Repeat these steps with the padding of the right cheek pad.
Warning: once the inner paddings made of expanding foam have been removed
from the cheek pads, ensure that the rear snap button "D", the top one "C", the
hook "A" and the NERS safety lever "B" are correctly hooked to the rear frame of
the fabric lining of the cheek pads (Fig.15); otherwise position them again appro-
priately.
3 DISASSEMBLING THE LINER
3.1 Release the left rear tab of the liner from the shell rear edge by slightly pulling the
comfort padding inwardly (Fig.16). Then repeat the operation with for the right rear
tab.
3.2 Hold the left front part of the liner and pull it upwards in order to remove the cor-
responding liner tab from the support fixed to the polystyrene inner shell (Fig.17).
Then repeat the steps with central front and right tabs as well.
3.3 Completely remove the liner from the helmet.
4 ASSEMBLING THE LINER
4.1 Insert the liner correctly into the helmet and have it well fitted against the base.
4.2 Insert the left front tab of the liner into the corresponding seat on the support fixed
to the polystyrene inner shell and push it downwards until it is completely hooked.
Repeat the operation with the central and right tabs too (Fig.17).
Warning: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat the
steps 3.2 and 4.2.
4.3 Insert the rear right and left tabs of the liner into the corresponding seats of the
shell edge (Fig.16). Push the tabs until they are fully hooked onto the support.
20
INSTRUCTIONS FOR USE