Nolan N808 Instructions D'utilisation page 19

- The VPS scratch resistant/fog-resistant treatment highly reduces fogging. Howev-
er, protracted periods of adverse weather and/or environmental conditions might
cause fogging and/or formation of condensation on the VPS, which entails a re-
duction of visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-resist-
ant treated VPS quickly reduces sharpness of vision, thus causing scarce visibility:
in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other ma-
terials might occur. These contaminations will cause marks and stains to come
out. In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended that the VPS does not come into contact with other materials.
3 DISASSEMBLY
3.1 Open the helmet visor and lower the VPS completely (see instructions above).
3.2 Hold the left lateral part of the sunscreen and pull it outwards with respect to the
helmet (Fig. 8).
3.3 Repeat the same operation on the right side of the helmet.
4 ASSEMBLY
4.1 Open the helmet visor completely and move the side slider until it stops (see in-
structions above) (Fig.6).
4.2 Insert the sunscreen left end into the left side guide until it is hooked in the shell
seat (Fig.8).
4.3 Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by activating and deactivating it (see
instructions above). If necessary, repeat the operations mentioned above.
- If the VPS opening and closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolangroup authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- side cheek pads (right and left)
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
To remove and/or fit the inner comfort padding, deactivate the VPS and open the visor
completely (see instructions above).
1 DISASSEMBLING THE CHEEK PADS
1.1 Open the chin strap (see specific instructions) and remove the chin strap band
from the loop on the cheek pad strap (Fig.9).
INSTRUCTIONS FOR USE
N80-8
19