Metabo HPT NR 83A5 Mode D'emploi page 24

English
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 3–7).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
DISCONNECT AIR HOSE.
Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
Rod
Outlet
Remove the jammed nail with a slotted screw
driver.
In case of frequent jam, contact a metabo HPT
authorized service center.
2. Inspecting the magazine
DISCONNECT AIR HOSE.
Clean the magazine. Remove plastic tips or
wooden tips which may have accumulated in
the magazine. Lubricate it with metabo HPT
pneumatic tool lubricant.
24
MAINTENANCE
WARNING
Disconnect
air hose
<NR83A5 / NR83A5 (S) / NR83A5 (Y) / NR83A5 (S1)>
Magazine
<NR83AA5>
Magazine
Nail Feeder Ass'y
3. Storing
○ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
○ Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
Nail Feeder
Disconnect
air hose
Disconnect
air hose