Metabo HPT NR 83A5 Mode D'emploi page 23

Shaft Ring
Body
(3) Inspection after assembly
Perform an after-assembly inspection according to
the procedure below.
Disconnect the air hose.
REMOVE ALL NAILS FROM NAILER.
□ THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Adjust air pressure to 70 psi (4.9 bar, 5 kgf/cm²).
Connect the air hose.
□ THE NAILER MUST NOT LEAK AIR.
Remove your fi nger from the trigger and press the
push lever against the workpiece.
□ THE NAILER MUST NOT OPERATE.
Separate the push lever from the workpiece. Next,
point the nailer downward, pull the trigger, and keep
that position for 5 seconds or longer.
□ THE NAILER MUST NOT OPERATE.
With the nailer off the wood, pull the Trigger. Next,
depress the Push Lever against the workpiece.
□ THE NAILER MUST OPERATE.
Next, depress the Push Lever against the workpiece.
Now pull the Trigger.
□ THE NAILER MUST OPERATE.
If no abnormal operation is observed, you may load
nails in the nailer.
Drive nails into the workpiece that are the same type
to be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
If a problem occurs during the inspection described
above, do not attempt to repair the nailer yourself;
please bring it to the nearest metabo HPT authorized
service center.
Trigger Pin
Trigger (A)
Fig. 4
USING THE NOSE CAP (except NR83AA5)
● Disconnect the air hose from the nailer
before attaching or removing the nose cap.
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
DISCONNECT AIR HOSE FROM NAILER.
Put the nose cap to the toe of the push lever.
NOTE:
● The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
Do not connect
air hose
Nose cap can be removed from the push lever using a
screwdriver or thin rod.
Screwdriver
English
WARNING
Nose
Push Lever
Nose Cap
Push lever
Nose cap
23