Melitta SOLO Mode D'emploi page 26

Transport, Storage and Disposal
Malfunction
Coffee only fl ows drop-by-
drop.
Coffee does not fl ow.
The grinder is not grinding.
Loud grinder noise.
Bean symbols
fl ashing although the bean
container is full.
Appliance indicates
"no water" even though the
water tank is fi lled.
illuminates on the
display.
illuminates on the
display.
The cleaning or descaling
process was interrupted.
The brewing unit can no
longer be reinserted after
removal.
The symbols for cleaning
and stand-by
alternately.
26
Troubleshooting
Cause
Grinding fi neness is too fi ne.
Water tank not fi lled or
incorrectly inserted.
The brewing unit is clogged. Clean the brewing unit.
The beans are not falling
into the grinder.
Foreign objects in the grinder. Call the hotline.
Foreign objects in the grinder. Call the hotline.
Insuffi cient quantity of
are
ground beans in the brewing
chamber.
The fl oat is blocked.
There is air in the lines
inside the appliance.
The power supply was
interrupted, e.g. due to a
power outage.
The brewing unit is not
properly locked.
The actuator is not in the
proper position.
The brewing unit is missing
or not properly inserted.
fl ash
The brewing chamber is
overfi lled.
Operating Instructions: Melitta
Measure
Adjust the grinding fi neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water tank and make sure it is
properly inserted.
Tap lightly on the bean container.
Press the buttons for single-cup
dispensing or two-cup dispensing
.
Check the condition of the fl oat in the
water tank, remove the water and
carefully shake the tank.
If necessary, fi ll the water tank and
press the button for coffee strength
. The appliance is then vented.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Check whether the handle for locking
the brewing unit is correctly engaged.
Switch the appliance off and then
on again. Then press the button for
single- and two-cup dispensing
and simultaneously for longer
than 2 seconds. The actuator is
put into position. Then reinsert the
brewing unit and make sure it is
correctly locked into place.
Insert the brewing unit properly and
lock.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until
standby mode is displayed.
Solo | 1828-0618 | 2018-08
® ®