Transport, Storage And Disposal - Melitta SOLO Mode D'emploi

Transport, Storage and
Disposal
Venting
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
■ Remove the water fi lter if necessary
("Water hardness and fi lter", page 20)
and keep it cool in a glass fi lled with tap
water.
■ Switch on the device.
■ Press the
and
simultaneously for approx. 2 seconds.
fl ashes, and then
■ Pull the water tank 6 up and out of the
appliance.
■ Empty the water tank.
■ Press the
button. The appliance is
automatically vented and then switched
off.
■ Insert the water tank into the appliance.
Operating Instructions: Melitta
buttons
illuminates.
Solo | 1828-0618 | 2018-08
® ®

Transport, Storage and Disposal

Transport
■ Vent the appliance.
■ Empty and clean the drip tray and coffee
grounds container.
■ Empty the water tank and the bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
■ "Cleaning the brewing unit", page 21.
■ If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
25