Switch Led Lamps On/Off; Stopping The Vehicle - Reely Micro Dune Fighter BL 2.0 Mode D'emploi

j) Switch LED Lamps On/Off
The four LED lamps at the top of the vehicle can be
switched on or off with a switch. The switch is below the
driver figures (see mark in the figure on the right) and can
be reached easily from behind, even when the car body
is installed.
k) Stopping the Vehicle
To stop driving, proceed as follows:
• Let go of the throttle/brake lever on the transmitter so
that it goes into neutral position, and let the vehicle run
out.
• After the vehicle has stopped, the speed controllers
switch off (switch position „OFF", see figure on the
right).
Never touch the wheels or the drive mecha-
nism, and make sure you do not move the
throttle/brake lever at the transmitter! Do not
hold the vehicle at its wheels!
Attention!
The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!
• Disconnect the drive battery from the speed controller. Disconnect the plug-in connection completely.
• Now you may turn off the transmitter.
45