Setting The Shock Absorbers - Reely Micro Dune Fighter BL 2.0 Mode D'emploi

11. Setting the Shock Absorbers

Front axle Rear axle
The spring-pre-tension at the upper end of the shock absorber can be adjusted by inserting plastics clips.
The shock absorbers at the front and rear vehicle axles can be mounted in different positions at the lower transverse
link (B). The manufacturer has, however, already chosen the best position; therefore, only professional drivers should
change these.
Always set the shock absorbers for one axle evenly (at the left and right wheels of the front or rear axle). Otherwise,
driving behaviour will be influenced negatively.
Professional drivers may also use springs with a different stiffness or damper oil of a different viscosity for filling the
shock absorbers. Installation of aluminium shock absorbers that can be adjusted with a knurled wheel is possible as
well.
Just as with a „real" car, the shock absorbers (or the rubber seals in them) on the model car are a wearing part. If oil
is running from the shock absorbers (e.g. transverse link strongly oiled, dripping traces), the seals or shock absorbers
must be replaced.
50