Switch On The Transmitter And The Vehicle; Controlling The Vehicle - Reely Rock-Crawler 1:10 Notice D'emploi

c) Switch on the Transmitter and the Vehicle
• Let go of the lever (E) so that it is in the middle position. Release the turning wheel (C).
Switch the transmitter on first now via the on/off switch (A) (switch position "ON"). The LED (B) at the transmitter
flashes.
• Switch on the vehicle with the on/off switch (L) at the bottom (switch position "ON").
• The transmitter now recognises the vehicle; the LED (B) stops flashing.
Always proceed in this order - first switch on the transmitter, then the vehicle. Ensure that you do not move
the lever (E) and the turning wheel (C) while switching on, but that they remain in their home positions
(middle positions).
d) Controlling the Vehicle
• Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.
• The lever (E) is used to drive the vehicle forwards and backwards and to stop it.
Driving forwards
• The turning wheel (C) steers the vehicle to the left and right during the drive.
Steering to the left
32
Stop
Steering to the right
Driving backwards