Olympus PT-038 Mode D'emploi page 57

Make sure the camera is loaded properly.
Check the following points before sealing the Case.
• Is the digital camera loaded properly?
• Is the mode dial set to "SCENE"?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-ring or the O-ring contact
surface on the front lid?
• Is the waterproof function maintenance performed?
Seal the Case.
1 Close the rear lid of the Case gently.
2 Turn the open/close dial clockwise.
• The Case is sealed when the dial is turned 180 degrees.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This
will cause water leakage.
• Close the rear lid of the Case so that the lens cap strap doesn't catch. If it
catches, water leaks may result.
EN
EN 19