GYS PROGYS 160LA Mode D'emploi page 9

WARNING - SAFETY RULES
GENERAL INSTRUCTIONS
Read and understand the following safety instructions before use.
Any modification and maintenance not specified in the instructions manual should not be undertaken.
The manufacturer is not liable for any injury or damage due to non-compliance with the instructions featured in this
manual.
In the event of problems or uncertainties, please consult a qualified person to handle the installation properly.
ENVIRONMENT
This equipment must only be used for welding operations in accordance with the limits indicated on the descriptive panel
and/or in the user manual. Safety instructions must be followed. In case of improper or unsafe use, the manufacturer
cannot be held liable.
This equipment must be used and stored in a room free from dust, acid, flammable gas or any other corrosive agent.
Operate the machine in an open, or well-ventilated area.
Operating temperature:
Use between -10 and +40°C (+14 and +104°F).
Storage between -20 and +55°C (-4 and 131°F).
Air humidity:
Lower or equal to 50% at 40°C (104°F).
Lower or equal to 90% at 20°C (68°F).
Altitude:
Up to 1000 meters above sea level (3280 feet).
INDIVIDUAL PROTECTION AND PROTECTION FOR OTHERS
Arc welding can be dangerous and can cause serious injury or even death.
Welding exposes the user to dangerous heat, arc rays, electromagnetic fields, risk of electric shock, noise and gas
fumes. People wearing pacemakers are advised to consult a doctor before using the welding machine.
To protect oneself as well others, ensure the following safety precautions are taken:
In order to protect yourself from burns and radiation, wear clothing without turn-up or cuffs. These
clothes must be insulated, dry, fireproof, in good condition and cover the whole body.
Wear protective gloves to guarantee electrical and thermal insulation.
Wear sufficient welding protective gear for the whole body: hood, gloves, jacket, trousers... (varies
depending on the application/operation). Protect the eyes during cleaning operations. Contact lenses
are prohibited during use.
It may be necessary to install fireproof welding curtains to protect the area against arc rays, weld spat-
ter and sparks.
Inform the people around the working area to never look at the arc nor the molten metal, and to wear
protective clothes.
Ensure ear protection is worn by the operator if the work exceeds the authorised noise limit (the same
applies to any person in the welding area).
Keep hands, hair and clothes away from moving parts such as fans, and engines.
Never remove the safety covers from the cooling unit when the machine is plugged in. The manufactu-
rer is not liable for any injury or damage caused due to non-compliance with the safety precautions.
Parts that have previously been welded will be hot and may cause burns if manipulated. During
maintenance work on the torch or the electrode holder, you should make sure it's cold enough and
wait at least 10 minutes before any intervention. When using a water-cooled torch, make sure that
the cooling unit is switched on to avoid any burns that could potentially be caused by the liquid.
It is important to secure the working area before leaving to ensure the protection of property and the
safety of others.
PROGYS 160LA EN
9