Miele PWM 514 Mode D'emploi page 122

en - Programme summary
Mops ch-th dis 20min+rtu
Fabric
Programme se-
quence
Extras
Mops rtu
Fabric
Programme se-
quence
Extras
New mops
Fabric
Programme se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit cleaning agents and disinfectants.
122
60 °C
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops chemo-
thermal disinfection*,
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Fill stop,
Rinse hold
Cotton, viscose, polyester and microfibre mops
1 rinse cycle
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Fill stop, Rinse hold
60 °C (Cold to 90 °C)
For washing new mops
Main wash up to 90 °C, wash time 4 min
Cool down can be activated in the Miele Bench-
mark Programming Tool
2 rinse cycles
Final spin
Soak, Water plus, Intensive, Rinse plus, Fill stop,
Rinse hold
Load ratio/Load
size
1:10
PWM 514 – 13 kg
PWM 520 – 18 kg
1:9
PWM 514 – 14 kg
PWM 520 – 20 kg
For number,
see
"Mops load size"
chart