Thermador P24WK Instructions D'installation page 8

FIG. 5 Side View of Cooktop
26-3/8"
3" TO CENTERLINE GAS
INLET
22-5/8"
23-3/8"
2"
Cabinet face for installation with projecting control panel
Cabinet face for installation with flush control panel
* Low Back required when there is less than
12" horizontal clearance from back of cooktop to
combustible material. With more than 12" of clear-
ance, the Island Trim may be used.
FIG. 8 Installation of 48" Cooktop above two
side-by-side Thermador Warming Drawers,
Model No. WD24
Minimum 3/4" (19 mm)
(22, 9 cm) 9"
2-3/4" (7 cm) Vertical Distance
Between Cutouts
(See Side View for Wood Support)
All manuals and user guides at all-guides.com
Step 2: Cabinet Preparation
FIG. 6 Projecting from
12"
1/2"
Side Flange
7-3/4"
3"
3/4"
Front projects outward 1-3/8" as
shown from standard 24"-deep
base.
0" to 2"
(0 - 51mm)
See Fig. 4
and Table
Di m ensi o n C
1-7/8" (4,8 cm)
Horizontal Distance Between Cutouts
6
Cabinet Front
5/8"
Notch
Depth
1-3/8"
Side View
Plywood support
Install additional
wood support along
front edge of cutout
FIG. 7 Flush to Cabinet
Front
* Provide clearance for screws
by increasing cutout height by
1/16" or by notching in the loca-
tion of the three screws.
2" Notch
Depth
Front flush with cabinets;
minimum
of 25-3/8" cabinet depth
required.
7 / "
-13
16
(19,8 cm)
2 3/4" (70 mm) minimum
between cutouts