Agri-Fab 45-0331 Notice D'utilisation page 7

11. (Figure 8) Position the height adjustment handle side to
side so that the tooth lock washer (M) can fi t between
the handle and the height adjustment strap. Tighten
the nuts securing the height adjustment handle.
12. (Figure 8) Insert the 5/16" x 3/4" carriage bolt (E)
through the height adjustment handle. Assemble onto
the bolt, in order, the 5/16" tooth-lock washer (M), the
height adjustment strap, a 5/16" fl at washer (J) and the
plastic knob.
5/16" FLAT
WASHER (J)
PLASTIC
KNOB
TOOTH LOCK
WASHER (M)
ASSEMBLY OF HOPPER BAG
1. (Figure 9) Turn a rear hopper tube so that the brace
holes in the middle of the tube face down. Slide the
tube through the two loops sewn to the top rear seam
inside the hopper bag.
INNER BAG LOOPS
REAR HOPPER TUBE
(brace holes on bottom)
5/16" x 3/4"
CARRIAGE BOLT (E)
ENGLISH
2. (Figure 10) Insert the two upper hopper side tubes
through the stitched fl aps on each side of the hopper
bag.
3. (Figure 10) Assemble the ends of the rear hopper tube
onto the ends of the upper hopper side tubes. Fasten
together using plastic plugs (Z).
8
4. (Figure 11) Turn the second rear hopper tube so that
the brace holes in the middle of the tube face up. As-
semble the ends of the rear hopper tube onto the ends
of the lower hopper side tubes. Fasten together using
plastic plugs (Z).
9
LOWER
HOPPER
SIDE TUBE
7
PLASTIC PLUG (Z)
UPPER HOPPER
SIDE TUBE
REAR HOPPER TUBE
(brace holes on top)
PLASTIC PLUG (Z)
10
11