Agri-Fab 45-0331 Notice D'utilisation page 6

If your tractor hitch has 11" to 13" ground clearance re-
fer to fi gure 4. If your tractor hitch has 8" to 11" ground
clearance refer to fi gure 5.
5. (Figure 4 or 5) Assemble the hitch brackets to the hitch
tubes using two 5/16" x 2" hex bolts (B) and 5/16" hex
lock nuts (G). The bolts should straddle the front hitch
tube bolt. Do not tighten yet.
6. At this time tighten the four bolts fastening the hitch
tubes to the sweeper housing. Next, tighten the two bolts
fastening the ends of the hitch tubes together. Finally,
tighten the two bolts fastening the hitch brackets to the
hitch tubes.
7. (Figure 4 or 5) Assemble the hitch pin (Y), two 3/4"
spacers (U) and the 1/8" hair cotter pin (N) to the hitch
brackets.
5/16" HEX
LOCK NUT (G)
5/16" HEX
LOCK NUT (G)
5/16" x 2"
HEX BOLT (B)
HITCH PIN (Y)
HITCH BRACKET
3/4" SPACER (U)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (N)
5/16" x 2"
HEX BOLT (B)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
3/4" SPACER (U)
HITCH BRACKET
1/8" HAIR
COTTER PIN (N)
ENGLISH
8. (Figure 6) Assemble the height adjustment handle to
the height adjustment tube as shown in fi gure six. Use
two curved head bolts (C), bowed washers (L), 5/16"
lock washers (K) and 5/16" hex nuts (H). Do not tighten
yet.
9. (Figure 6) Assemble the grip onto the height adjustment
handle.
5/16" HEX NUT (H)
5/16" LOCK
WASHER (K)
BOWED
WASHER (L)
4
CURVED
HEAD BOLT (C)
10. (Figure 7) Insert a 5/16" x 3/4" hex bolt (F) through the
angle bracket. Assemble onto the bolt (in order) the
spacer bushing (T), the height adjustment strap, a 5/16"
fl at washer (J) and a 5/16" hex lock nut (G). Tighten.
5
6
GRIP
HEIGHT
ADJUSTMENT
HANDLE
5/16" x 3/4"
5/16" FLAT
HEX BOLT (F)
WASHER (J)
SPACER
BUSHING (T)
5/16" HEX
LOCK NUT (G)
HEIGHT
ADJUSTMENT
STRAP
6
7