Publicité
Les langues disponibles
Les langues disponibles
show 'Pass' or 'Fail' on the display (a voice
announcement will be played within 5 seconds).
5.
Once you have completed the cloning process,
turn the radios OFF and ON to exit the 'cloning'
mode.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
When ordering the MUC, refer to P/N#
PMLN6384_.
Notes:
•
If cloning fails, refer to "What To Do If Cloning
Fails" on page 46.
•
Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
•
MUC pockets numbers should be read from left to
right with the Motorola Solutions logo facing front.
44
English
CPS and Cloning Cables (Optional
Accessory)
•
Both CPS and Cloning Cables are made to work
either with RM Series radios or RDX Series
radios. Cloning cable supports a mix of RM and
RDX series radios.
•
CPS cable programs RM series radios. Make
sure the cable switch is in "Flash" position. To
program a RDX radio with the CPS cable, make
sure the cable switch is in "CPS" position and the
USB converter provided in the CPS cable kit is
attached to the cable.
•
Cloning cable allows you to clone:
–RM Series radios. Make sure the switch is in
"Cloning" or "Legacy" position.
–RDX Series radios. Make sure the switch is in
"Legacy" position with one USB converter on
each end of the cloning cable.
–RM Series and RDX Series radios. Make sure
the switch is in "Legacy" position and use a
USB converter to the RDX Single-Unit Charger.
The Cloning Cable Kit provides 1 USB
converter.
Publicité
