Publicité
Les langues disponibles
Les langues disponibles
Setting VOX Sensitivity
The sensitivity of the radio's accessory or
microphone can be adjusted to suit different
operating environments. VOX sensitivity can
be programmed via the CPS.
Default value is OFF. If you want to use the
VOX feature, VOX level should be set at a
value different from OFF.
•
1 = High audio input levels trigger the Tx
•
2 = Medium sensitivity
•
3 = Low audio input levels trigger the Tx
Microphone Gain
The sensitivity of the microphone can be
adjusted to fit different users or operating
environments.
This feature can be adjusted only through the
CPS. Microphone default setting is set to level
2 (medium gain).
Hands Free Without Accessories (iVOX)
•
Enable iVOX by pressing the PTT button while
30
English
turning ON the radio.
•
Pressing the PTT button can temporarily disable
the iVOX operation.
Note:
There is a short delay between the time
when you start stalking and when the radio
transmits.
Power Up - Tone Mode
To enable/disable power up tone mode, press
SB1 and SB2 buttons simultaneously for 2-3
seconds while powering up the radio until you
hear a quick succession of beeps and an
audible voice announcement.
Reset to Factory Defaults
Reset to Factory Defaults will set back all radio
features to the original factory default settings.
To do so, press PTT, SB2 and SB1
simultaneously while turning ON the radio until
you hear a high tone chirp.
Toggle Voice Prompt in User Mode
Short press the SB1 button while turning ON
the radio to enable/disable Voice Prompt in
User mode. This mode is set to ON by default.
Publicité
