Publicité
Les langues disponibles
Les langues disponibles
EN
Trouble type
How to check it
1. Is the voltage of the
accumulator over 10V ?
The vehicle
2. Will the vehicle move
moves slowly
faster when the motor
(with gear box) is
connected directly with
the accumulator?
1. Does the accumulator
The accumulator
loose or drop?
cannot be
charged
2. Is the charger a little
hot when charging?
1. Is the sound switch in
good condition?
The vehicle is
2. Check the wires and
normal but
the connectors from the
without sound
head to the accumulator
and see if it is in good
condition?
1. Do the wheels move
well?
Wheels don't
work
2. Check the gearbox,
and see if the gears at
all levels are damaged?
1. Does the vehicle
overload than 30kg?
The vehicle
2. Is the road the car
often stops
drives not flat?
when moving
3. Can the free wheels
be turned freely?
lf you cannot solve the problems according to above steps, please
contact with your supplier.
20
How to solve
If not, charge it.
If yes, see the next.
If yes, the driving circuit
board is broken, contact with
your supplier.
If not, check the next.
If yes, connect well.
If not, check the next.
If yes, the charger is broken
change a new one.
If not change the media
control panel.
If yes, check the next.
If not, connect it well.
If yes, let the wheels touch
ground.
If not, check the next.
If yes, change a new gearbox.
If yes, its normal.
If not, check the next.
If yes, drive on flat road.
If not, check the next.
If not, the wheel and axle
have no problem.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1)This product may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, it may cause harmful interterence to radio
communications. However, there is no guarantees that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
● Consult an experienced radio/TV technician for help.
WARNING: Any changes or modifications to this unit without the
express approval by the compliance party could void the user's
authority to operate the equipment.
Responsible party (contact for FCC matters only):
Quality Control Dept.
EN
21
Publicité
