SICK GTB20 Manuel D'instructions page 27

5 Electrical installation
8026846.1K1C/2023/06/07 | SICK
Subject to change without notice
0.6 ... 0.8 Nm
0.4 ... 0.5 Nm
0.8 ... 1.3 Nm
1
Figure 1: Tightening torque
See table 2 and table 3.
1
CAUTION
Please provide adequate strain relief externally for the cable if necessary. The back
cover must be completely sealed before operation.
Note the preferred direction of the object relative to the sensor, cf.
page 27.
Figure 2: Alignment of the sensor relative to the object direction
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
– Terminal connection: Pin assignment
Terminal connection:
1. Untighten the M3 screw on the back cover and remove the back cover.
OPERATING INSTRUCTIONS
< 0.4 Nm
O P E R A T I N G I N S T R U C T I O N S | GTB20
see figure 2,
27
en