Publicité
Les langues disponibles
Les langues disponibles
Before you start...
Your safety and the safety of others are very important.
We have provided many important safety messages in this
manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill
or hurt you and others.
All safety messages will follow the safety alert symbol and
either the word "DANGER" or "WARNING". These words mean:
You can be killed or seriously injured if you don't
immediately follow instructions.
WARNING
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is,
tell you how to reduce the chance of injury, and tell you what
can happen if the instructions are not followed.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
— Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Page 2
All manuals and user guides at all-guides.com
DANGER
Important: Observe all governing codes and ordi-
nances.
Do not obstruct flow of combustion and ventilation air.
This installation must conform with all local codes and
ordinances. In the absence of local codes, installation
must conform with American National Standard,
National Fuel Gas Code ANSI Z223.1 — latest edition**
or CAN/CGA — B149 — latest edition* installation
codes.
It is the customer's responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation is adequate
and in conformance with National Electrical Code,
ANSI/NFPA 70 — latest edition**, or CSA Standard
C22.1, Canadian Electrical Code, Part 1 — latest
edition *, and all codes and ordinances.
Cabinet opening dimensions shown must be used. Given
dimensions are minimum clearances.
When installing a range under existing cabinets and the
installation does not meet the minimum cabinet clearances,
install a range hood above the range to avoid burn hazards.
Proper installation is your responsibility. A qualified
technician must install this range. Make sure you have
everything necessary for correct installation. It is the
installer's responsibility to comply with installation
clearances specified on the gas information label. The gas
information label and model/serial rating plate are located
on the frame behind the storage drawer.
Copies of the standards listed may be obtained from:
* CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
** National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
Publicité
