Publicité
Les langues disponibles
Les langues disponibles
Gas conversions
hood
pin
Natural gas
increase gas
increase
flame size
pre-set at factory
for Natural gas
6.
Oven burner: Use 1/2" combination wrench to turn the
orifice hood down snug onto pin (approximately 2 to 2-1/2
turns). DO NOT OVERTIGHTEN. The burner flame cannot be
properly adjusted if this conversion is not made.
7.
Complete installation sections D through E, Pages 9-11.
Check for proper flame. The small inner cone should have a
very distinct blue flame 1/4" to 1/2" long. The outer cone is
not as distinct as the inner cone. L.P. gas flames have a
slightly yellow tip. If the flame is noisy or blowing, it is
getting too much air. If the flame is soft and lazy, it is not
getting enough air.
Natural gas conversion
1.
Check that main gas supply line has been shut off and
the power supply cord is disconnected.
2.
pressure
regulator
Remove
burner grates.
pressure
regulator
Nat. gas
DO NOT REMOVE THE PRESSURE REGULATOR.
All manuals and user guides at all-guides.com
cont.
L.P . gas
decrease
gas
decrease
flame size
orifice hood
L.P .
Natural
cap
washer
3.
Open broiler drawer to locate pressure regulator.
Pressure regulator: Remove plastic cover. Turn cap marked
"L.P. " on front of pressure regulator counterclockwise with a
wrench to remove. Do Not disturb or remove the spring
beneath the cap. Turn the cap over and reinstall cap on
regulator so that the letter "N" is visible. Replace plastic
cover over cap.
air shutter
4.
Cooktop burners: Lift up cooktop maintop until it is
held in place by support rods. Remove shipping screws from
each burner. Remove burners.
orifice spuds
NAT
plastic
cover
L.R.
5.
Locate Natural gas orifice spuds in literature
package. All Natural gas orifice spuds are stamped with "54" .
plastic
Remove L.P. gas orifice spuds using a 3/8" combination
cover
wrench. Install Natural gas orifice spuds to replace the L.P.
gas orifice spuds.
Place L.P. gas orifice spuds in plastic parts bag for future use
and keep with literature package. Reinstall burners. Lower
maintop to operating position. Reinstall burner grates.
L.P . gas
Remove and
replace orifice
spuds.
notches
L.P .
gas
manifold
L.F.
R.F.
R.R.
shipping
screw
burner
Page 13
Publicité
