Publicité
Les langues disponibles
Les langues disponibles
Page 5 of 15
FITTING INSTRUCTIONS FRONT
•
Remove the four bolts arrowed in picture 1 and remove the screen.
•
Remove the two bolts arrowed in picture 2.
•
Remove the two bolts arrowed in pictures 3 and 4.
•
Carefully pull the indicator/headlight housing forward to allow access to the wiring plug
sockets.
•
Disconnect the indicator wiring plug sockets arrowed in pictures 5 and 6.
•
Remove the screw arrowed in picture 7 and remove the clamp plate.
•
Carefully squeeze the indicator stem and remove the original indicator as shown in
pictures 8 and 9.
To fit the indicators of choice (R&G mini indicator product code RG370 for bulb type and
RG371 for LED type or RG372 for Aero Style led type)
•
Feed the new indicator wiring through the hole in one of the indicator adaptors (item 1)
and offer up to the indicator aperture as shown in picture 10 (so the shaped location
spigot will fit into the aperture).
•
Feed one of the remaining indicator adaptors (item 1) over the wiring and into the inside
face of the indicator aperture as shown in picture 11.
•
Fit the indicator nut and tighten as shown in picture 11.
•
Feed the indicator wiring through one of the nut/wire covers (item 2) as shown in pictures
below (it helps if a small amount of liquid detergent is used) and position the nut cover over
the nut.
•
Fit one length of heat-shrink (item 4) over the wires of each indicator so the heat-shrink fits
over the stem of the nut/wire cover and gently heat until the heat-shrink contracts to the
wiring and nut/wire cover as shown in pictures below (repeat the above for the opposite
indicator).
•
Reconnect the indicator to the original wiring
plug socket using the supplied connector (item 3) as shown in picture 12 (it is a good
idea to test the indicator at this stage if illumination fails, swap the bullet connections
around). You may need to use a resistor, (sold separately) to achieve the correct flash
rate.
•
Repeat the above for the opposite indicator.
•
It is a good idea to retest the indicators at this stage.
•
Refit the headlight unit as original ensuring no wires are caught when refitting.
•
Please check the operation of indicators and steering before riding the motorcycle
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com
IA0017
Email:
info@rg-racing.com
Publicité
