Tunturi 17TBE60000 Manuel D'assemblage page 16

English
- Only use the equipment in environments
with adequate ventilation. Do not use the
equipment in draughty environments in order
not to catch a cold.
- Only use the equipment in environments with
ambient temperatures between 10°C~35°C/
50°F~95°F. Only store the equipment in
environments with ambient temperatures
between 5°C~45°C/ 41°F~113°F.
- Do not use or store the equipment in humid
surroundings. The air humidity must never be
more than 80%.
- Only use the equipment for its intended
purpose. Do not use the equipment for other
purposes than described in the manual.
- Do not use the equipment if any part is
damaged or defective. If a part is damaged or
defective, contact your dealer.
- Keep your hands, feet and other body parts
away from the moving parts.
- Keep your hair away from the moving parts.
- Wear appropriate clothing and shoes.
- Keep clothing, jewelry and other objects away
from the moving parts.
- Make sure that only one person uses the
equipment at a time. The equipment must not
be used by persons weighing more than 135 kg
(300 lbs).
- Do not open equipment without consulting
your dealer.
Electrical safety
(Only for equipment with electric power)
- Before use, always check that the mains voltage
is the same as the voltage on the rating plate of
the equipment.
- Do not use an extension cable.
- Keep the mains cable away from heat, oil and
sharp edges.
- Do not alter or modify the mains cable or the
mains plug.
- Do not use the equipment if the mains cable or
the mains plug is damaged or defective. If the
mains cable or the mains plug is damaged or
defective, contact your dealer.
- Always fully unwind the mains cable.
- Do not run the mains cable underneath the
equipment. Do not run the mains cable
underneath a carpet. Do not place any objects
on the mains cable.
- Make sure that the mains cable does not hang
over the edge of a table.
16
- Make sure that the mains cable cannot be
caught accidentally or tripped over.
- Do not leave the equipment unattended when
the mains plug is inserted into the wall socket.
- Do not pull the mains cable to remove the
mains plug from the wall socket.
- Remove the mains plug from the wall socket
when the equipment is not in use, before
assembly or disassembly and before cleaning
and maintenance.
Assembly instructions
Description illustration A
The illustration shows what the trainer will looks
like after the assembly is completed.
You can use this as a reference during your
assembly, but do follow the assembly steps
always in the correct sequence as showed in the
illustrations.
Description illustration B
The illustration shows what components and parts
you should find when un-boxing your product.
‼ NOTE
• Small parts can be hidden/ packed in hollow
spaces in the Styrofoam product protection
• If a part is missing, contact your dealer.
Description illustration C
The illustration shows the hardware kit that comes
with your product.
The hardware kit contains bolts, washers, screws
, nuts etc. and the required tools to properly fit
your trainer.
Description illustration D
The illustrations shows you in the correct following
order how to assembly your trainer best.
‼ NOTE
• Part numbers shown in the assembly steps
are commencing with the spare part drawing
that can be found in the online version user
manual.