Télécharger Imprimer la page

Maytag MDB7759AWS4 Instructions D'installation page 16

Publicité

Les langues disponibles

Les langues disponibles

Move Dishwash
iose to Cobinel
py,
er.
ON ping gy, yy 3 yoy
Opening.
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Stand dishwasher upright
Using 2 or more people, stand dishwasher. upright.
NOTE: Do not install kick plate until instructed to do so.
Move
dishwasher close to
cabinet opening
ey
IMPORTANT:
Double-check correct placement of utilities. Grasp
the sides of the dishwasher at the edges of the door panel. Tilt
dishwasher backward on wheels and move dishwasher close to
cabinet opening.
NOTE: Do not push on the front of the panel or on the console.
Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations
shown to prohibit them from moving when dishwasher is moved
into the cabinet opening.
16
Check water and drain
hose position
"
Check that water line is on the left side of opening and drain hose
is near the center of the cabinet opening.
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes or
falls open under its own weight, the door tension will need to be
adjusted.
Closes too quickly—
Decrease spring tension
To adjust the door spring tension, unhook the spring from the rear
leg of dishwasher.
Using a %e" nut driver or hex socket, remove the screw from the
tensioner.
The screw can be put into one of three holes (1, 2, 3) in the front
leg of dishwasher. If the door closes by itself, move the tensioner
to a higher number hole and replace the screw. Reattach door
spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should be secured
at same holes.

Publicité

loading

Ce manuel est également adapté pour:

Mdb8959aws7