Publicité
Les langues disponibles
Les langues disponibles
Select UL Listed/CSA Approved twist-on wire connectors rated to
connect your power supply cord to 16-gauge dishwasher wiring.
°
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors.
Wiring configuration
Power-supply wire:
Terminal box wire:
white =<
white
black -<——»- black
ground -wire «<—_—» ground connector
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power Supply Cord—
Connect ground wire
Remove the green grounding screw and place through the ring
terminal of the green ground wire. Reattach and tighten the green
screw.
Power Cord—Connect
remaining wires
O
b\ |
R
CO
Ww,
NYS
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
If needed, see website for animated representation of this step.
Visit www.maytag.com/electrical under FAQ tab.
4 | Power Cord—Secure cord
on strain relief
iG,
Tighten strain relief screws to secure cord.
5 | Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 4" nut driver and previously removed
screw to secure cover.
NOTE: Do not plug into outlet until instructed to do so.
13
Publicité
