Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Issue
Can't control the display with the remote control
No image and no sound
The display turns off suddenly
When connecting to the PC (HDMI), no signal is detected
TESTING AND COMPLIANCE
FCC INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other
channels is not possible.
Resolution
1.
Check if anything such as tape has been placed over
the receiver.
2.
Check if there is any obstacle between the display and
the remote control.
3.
Replace the batteries with new ones.
1.
Check if the display is turned on.
2.
Check if the power cord is connected to a wall outlet.
3.
Check if there is a problem in the wall outlet by
connecting other products.
1.
Check the power control settings. The power supply
may be interrupted.
2.
Check if the auto-off function is activated. See
Scheduler Settings, page 13.
3.
If there is no signal while the display is on, the display
will turn off automatically after 15 minutes of
inactivity.
Turn the display off/on using the remote control.
1.
Reconnect the HDMI cable.
2.
Restart the PC with the display on.
English - 45 -
Publicité
