Publicité
Les langues disponibles
Les langues disponibles
RST
Restart
Sets panel Volume,
STV
parameter value will ve set
for volume level
GTZ
Get Time Zone
CTZ
Change Time Zone.
STL
Set panel Language
Set mac address
Note: This command is
not available for MB230
platform. Instead, set_
mac_address command
SMA
can be used.
Note2: This command only
changes mac address of
wired interface.
Note3: Reboot needed.
get_mac_address
Get mac address
Gets mac address of
GETMACADDRESS
selected network interface
GETGPIO
Gets the GPIO's state
SETGPIOLOW
Sets the GPIO's state to low pin number(visit the GPIO List)
Gets the GPIO's state to
SETGPIOHIGH
high
SELECTSOURCE
Select source.
Set static IP, Default
Gateway and SubnetMask
SSIP
addresses (seperate
addresses with "-"
character)
no parameter
or
int (wait seconds until Restart)
integer (volume level)
no parameter
integer (gmt value )
string-int (please look at
abbreviations of languages)
string-int ( ex: eth0-
00:09:df:86:34:25)
none
none
pin number(visit the GPIO List)
pin number(visit the GPIO List)
integer n (7 = HDMI1, 8 =
HDMI2,9 = HDMI3, 10 =
HDMI4, 19 = DP, 20 = OPS, 26
= TYPE C )
string ( ex: 192.168.0.15-
10.0.90.5-255.255.255.0)
AUDIO COMMANDS
English - 27 -
#Display will be restarted
#Volume set level= ...
#Timezone is ...
#Timezone setup SUCCEEDED
#Language changed to ...
or
#Wrong language selection.
#SetMacAdress Successful
#*FAILURE - Invalid mac address!
#*FAILURE - Could not write MAC
address!
#*Hwaddr: mac_address -
Succesfull
#*Hwaddr: <mac_address> -
Succesfull
or
#*Mac address could not be
obtained
#*GPIO level is ...
#*... is set to HIGH
#*... is set to LOW
#*Select external source: ...
#IP address setting Succesfull
Publicité
