Publicité
Les langues disponibles
Les langues disponibles
GETCUSTOMER
BUILDINFO
FACTORY
RESET
MENUTIMEOUT
GETMENUTIMEOUT
AUTOTVOFF
GETAUTOTVOFF
GETSTANDBY
ENTERACTIVE
STANDBY
EXITACTIVESTANDBY
GETTVLIFETIME
Get Customer name
Reports the build info.
Load factory settings to
NVRAM.
Settings are updated with
defaults.
Reset the device.
Set menu time out mode.
Get menu time out mode
Set auto panel off level.
Get auto panel off mode.
Get standby on/off.
Enter active standby state
Exit active standby state
Prints panel life time in
minutes.
English - 33 -
no parameter
no parameter
no parameter
no parameter
integer n (n = 0 , n = 15, n =
30,n = 45, n = 60)
no parameter
integer n (0 = off,
1 = 1 HOUR,
2 = 2 HOUR,
3 = 3 HOUR,
4 = 4 HOUR,
5 = 5 HOUR,
6 = 6 HOUR,
7 = 7 HOUR,
8 = 8 HOUR )
no parameter
no parameter
no parameter
no parameter
no parameter
#*Customer:
[CUSTOMER]#*
#*Build info = ...
#*Build Date = ...
#*Factory Settings were loaded
to NVRAM.
#*Reset hardware
#*set menu timeout mode
to OFF
or
#*set menu timeout mode to 60
or
#*Invalid menu timeout mode
#*menu timeout mode is OFF
or
#*menu timeout mode is n
or
#*can not get menu timeout
mode
Note: Above n is one of (15,
30,45, 60)
#*set auto display off mode to n
or
#*set auto display off mode
to OFF
or
#*auto display off must be
Integer and between [0-8]
#*auto Display off is n
or
#*auto Display off is OFF
#*standby off
or
#*standby on
#*Display will be sent to Active
Standby state!
or
#*Display is in Active Standby
state already!
#Display will be turned on!
or
#* Display is not in Active
Standby state!
#*Display Life Time: n
Publicité
