Panasonic AJ-RC5 Mode D'emploi page 8

Parts and Their Functions
MON SEL
SUP
B
SEQ
G
ENC
U
R
IRIS RANGE
V
FULL
SENSITIVITY
W
RANGE
X
Remote Control Operation Panel AJ-
W SENSITIVITY control
This is used to control the operation range of the iris control joystick Y when the IRIS RANGE
switch V is at OFF.
X RANGE control
This is operational when the IRIS RANGE V switch is not set to FULL. It is used to coarsely
adjust the iris.
Y Iris control joystick
When the IRIS switch M is at AUTO, the position set by the joystick is incremented or
decremented to the AUTO IRIS LEVEL setting on the SETUP menu.
When the IRIS switch M is at MANUAL, the joystick is used to adjust the iris.
<Note>
Set the MANUAL/AUTO selector switch on the lens to AUTO.
Z M.PED control
This is used to set the master pedestal level.
PED
PREVIEW
IRIS
(PUSH)
U MON SEL selector switch
This switch is used to select the signals
which are output from PIX OUT or WFM
OUT on the base station.
V IRIS RANGE switch
This switch's setting takes effect when the
IRIS switch M has been set to MANUAL.
Y
When the IRIS RANGE switch is not at
the FULL position, the iris can be coarsely
Z
adjusted by the RANGE control X and
finely adjusted by the iris control joystick
Y. In addition, the joystick's operation
range can
SENSITIVITY control W. When the IRIS
RANGE switch is set to FULL, the
SENSITIVITY control W and the RANGE
control X do not operate, and the iris is
controlled using the iris control joystick Y.
E-7
be varied using the