Panasonic AJ-RC5 Mode D'emploi page 7

Parts and Their Functions
K
J
CALL
T
GAIN FILTER GAMMA
S
R
MON SEL
Q
M IRIS switch
This is the iris selector switch. Either AUTO or MANUAL is selected.
N AUTO IRIS indicator
This comes on when the IRIS switch M is set to AUTO.
O EXTENDER indicator
This comes on when the extender (a2) of the camera lens is used.
P CHECK button
By pressing this button in succession, the GAIN indicator S > FILTER indicator R >
GAMMA indicator T come on in this order, and the GAIN value, FILTER position and master
GAMMA value are displayed respectively on the numerical display LED.
Q Numerical display LED
This indicates the f-value of the lens. When the GAIN, FILTER or GAMMA setting is changed,
it displays the corresponding value. When the CHECK button P is pressed in succession, the
f-value, GAIN value, FILTER position, master GAMMA value and f-value are displayed
respectively.
<Note>
" - - - " appears on the LED when the power to the camera main unit is off or when the base
station front panel operations are effective (refer to the AJ-BS900H Operating Instructions).
R FILTER indicator
This comes on when the FILTER position appears on the numerical display LED.
S
GAIN indicator
This comes on when the GAIN value appears on the numerical display LED.
T GAMMA indicator
This comes on when the master GAMMA value appears on the numerical display LED.
L
TALLY
IRIS
MANUAL
AUTO
EXTENDER
CHECK
P
J CALL button
This button is used to call the camera.
When the camera is called, the button's
M
LED comes on.
K R TALLY indicator
N
This indicates the R TALLY signal which
O
is input from the TALLY IN connector of
the base station.
L G TALLY indicator
This indicates the G TALLY signal which
is input from the TALLY IN connector of
the base station.
E-6