Publicité
Les langues disponibles
Les langues disponibles
EN
PAIRING PROCEDURE
The remote control for your BOREA Connect speaker is radio-controlled and factory-paired with
the speaker. If your remote control does not work, has been replaced or if the batteries have been
changed, it is necessary to pair it again with your speakers.
Please turn ON the speaker with the back panel switch and wait for 3 seconds. Press continuously
«EQ reset» button on the remote for 5 seconds while watching the speaker LED on the front panel.
This LED will blink a couple of time after successful pairing (within a few seconds).
USING THE REMOTE CONTROL
1- BT PAIR button
The BOREA Connect speakers have the capability to memorize 8 devices. The 9
Bluetooth
th
connection will replace the first connected device. This function allows you to disconnect a Bluetooth
source to connect a new one. Press and hold the button «BT PAIR» to activate this function when
using the Bluetooth input of the BOREA Connect. The indicator light on the front panel should now
blink blue.
You can use your smartphone, tablet or computer to select the BOREA Connect in the list of
available Bluetooth devices.
2- BASS BOOST ON / BASS BOOST OFF button
At low volumes, we hear the low frequencies differently than at medium or high volumes. This
function balances the low frequencies at low volume and adapts gradually when the volume
changes. It is particularly recommended when listening to ambient music.
The BASS BOOST function adapts itself to the speaker volume.
3- DIMMER button
The DIMMER function allows you to deactivate the indicator light on the front of the active speaker.
Press and hold the «DIMMER» button. The indicator light will only blink when using the remote
control. It will also be active when the speakers are in standby mode.
4- RESET EQ button
The RESET EQ function resets the sound settings to their defaults. (Factory settings)
29
Publicité
