Simu T3.5 DC ESP Hz 12V Notice Originale page 9

Manual setting for awnings without blockers for UP end limit (ex: folding arm awnings):
1- Move the motor to the desired DOWN end limit position using the DOWN and UP
buttons. (If you hold the UP or DOWN button for more than 2 seconds the awning
will move automatically in the up or down direction. You will then have to stop the
awning at the wished end-limit position by pressing the STOP button.)
2- To set the DOWN end limit position, press simultaneously the STOP and UP
buttons. The motor will run automatically in the UP direction.
3- Before the motor reaches the UP end limit, press the STOP button.
4- If necessary adjust the position with the UP and DOWN buttons
5- To set the UP end limit position, press simultaneously the STOP and DOWN
buttons. The motor will run automatically in the DOWN direction.
6- Press STOP button to stop the motor.
7- To confirm the end limits press for 2 seconds on the stop until the motor jogs.
The operation is completed. Go to section 3.
If you do not want to use this transmitter as the individual control:
- Switch the power supply off (2 seconds minimum).
- Repeat the operation 2.1* with a new transmitter and then go to section 3.
* In this case, the motor will jog in both direction, which means that the limit
adjustment is already done.
3
Programming the first individual point of control
This operation can only be performed from the transmitter that was used for operation 2.1.
- Press the transmitter PROG Key for approximately 1 second. The motor
will jog in both direction.
The operation is completed.
Your transmitter is now programmed to control the motor in stable
mode.
4
Programming/adding a new (individual, group, or main) control point
a- Open the memory of the receiver from the individual control
transmitter:
- Press the PROG key of the transmitter for about 3 seconds until the motor
jogs in both directions.
b- Confirm the operation from the new transmitter you wish to add:
- Press the PROG key of the transmitter less than 1 second. The motor will
jog in both directions.
The operation is completed.
- For group controls, repeat operations a and b for each motor in the group.
- For general controls, repeat operations a and b for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations a with a programmed transmitter, then perform the
operation b with the transmitter to be deleted.
1-
2-
3-
4-
5-
6-
7-
2s.
1
PROG 1s.
a-
1
2
PROG ≥ 3s.
b-
1
2
PROG ≤ 1s.
3/6