7
"Back impulse" function
This function back tensions the fabric after an opening order. This function will only be activated once the installation
of the motor is completed.
To activate the function set the angle between 11 and 180° (to disable the Back impulse, set the angle to 0°):
1- Move the motor to the DOWN end limit with the DOWN button.
2- Press simultaneously for 5 seconds the UP and STOP buttons, The
motor jogs in both direction.
3- Adjust the angle of back impulse function (between 11 and 180°) with the
UP and DOWN buttons.
4- Confirm the setting by pressing 2 seconds the STOP button. The motor
jogs.
The new setting is memorized.
The «back impulse» function is disable in the factory mode.
8
"Back release" function
This function enables the release of the fabric tension after the complete closing of the box awning.
For safety reasons, this function can only be activated or deactivated by the
individual control point in 3 situations:
After the settings confirmation and before programming the first control
point.
After programming the first control point and during the next 4 cycles.
After a single power outage and during the next 4 cycles :
To activate or deactivate this function, the procedure is the same:
1- Retract the awning using the UP key.
2- Press simultaneously the STOP and DOWN keys for 5 seconds, the
motor jogs in both direction.
The operation is completed.
The "back release" function is disable in the factory mode.
9
End limit re-adjustment
9.1 - DOWN end limit re-adjustment:
1- Move the motor to the DOWN end limit previously set in section 2.3 with
the DOWN key.
2- Press simultaneously for 5 seconds the UP and DOWN keys, the motor
will jog in both directions.
3- Move to the new position with the UP and DOWN keys.
4- Confirm the new position by pressing 2 seconds the STOP key. The
motor will run for 0,5 second in one direction and then in the other
direction. The new end limit setting is memorized.
1-
2-
5s.
3-
between 11° and 180°
4-
2s.
1-
2-
5s.
1-
2-
3-
4-
5s.
2s.
5/6