Solar Panel; Learning Mode - Simu T3.5 DC ESP Hz 12V Notice Originale

1.2.1- Powered by SIMU batter (9014734) :
Battery 12V-2.2Ah ref : 9014734
1.2.2- Powered by one another battery (not SIMU) :
blue
brown
Battery characteristics :
Output voltage between 11,5V and 14V (±0,5V)
Output current: 5 A at 12V (starting current : 7 A during 400 ms with a voltage drop of 2 V max.)
2
End-limit setting

2.1 - Learning mode:

a- Connect the motor to the 12V power supply.
b- Press simultaneously on the UP and DOWN buttons of a Hz transmitter.
The motor will jog (turns 0.5 second in one direction and then in the
other).
This transmitter now controls the motor in constant pressure mode.
Go to section 2.2.
2.2 - Test and change the rotation direction:
Press on the UP button on the transmitter:
a- If the tube turns in the UP direction, go to section 2.3
b- If the tube runs in the DOWN direction, reverse the rotation
direction by pressing the STOP button for at least 3 sec until the
motor jogs. Confirm that the new rotation direction is now correct.
Go to section 2.3.
2.3 - End limit adjustment:
Semi-automatic setting for awnings with blockers for UP end limit (ex Box awnings, ..):
1- Move the motor to the desired DOWN end-limit position using the UP and DOWN
buttons. (If you hold the UP or DOWN button for more than 2 seconds the awning
will move automatically in the UP or DOWN direction. You will then have to stop the
awning at the desired end-limit position by pressing the STOP button.)
2- To set the DOWN end limit position, press simultaneously the STOP and UP
buttons. The motor will run automatically in the UP direction.
3- Press STOP button to stop the motor.
4- To confirm the end limits press for 2 seconds on STOP until the motor jogs.
The operation is completed. Go to section 3.
2/6
12 V Solar panel
12V NiMH battery
FUSE :
3 Nm = 2 AT
6 & 10 Nm = 3,15 AT
T3.5 DC ESP Hz
12V solar panel
0,75 mm
a-
12 V
ON
a-
OK
b-
1-
2-
3-
4-
b-
§2.3
3s.
OK §2.3
2s.