Simu T3.5 DC ESP Hz 12V Notice Originale page 10

5
Programming a Wind/Wind Sun sensor
a- Open the memory of the motor from the individual control
transmitter:
- Press the PROG key of the transmitter for about 3 seconds until the motor
jogs in both directions.
b- Confirm the operation from the sensor you wish to add:
- Press the PROG key of the sensor less than 1 second. The motor will jog
in both directions.
The operation is completed.
- For group controls, repeat operations "a" and "b for each motor in the group.
Recommendations when using a sensor: If the Wind sensor on an installation is changed or deleted, it is important
to delete it from the memory of all the motors in which it was programmed: perform operations a with a programmed
transmitter, then perform the operation b with the sensor to be deleted.
6
« Closing force » function
This function allows the closing force of the awning cassette to be increased or decreased to 3 levels (high/medium/low).
Contact the awning's manufacturer before using these functions to check the compatibility of your systems.
For safety reasons, this function can only be accessed via the individual control point in 3 situations:
- After the settings confirmation and before programming the first control point.
- After programming the first control and during the next 4 cycles.
- After a single power outage and during the next 4 cycles.
1- Position the motor to the halfway position using the DOWN or UP button.
Press the STOP button to stop the awning.
2- To activate closing force function press successively:
- For half a second press simultaneously STOP and UP buttons, without
the motor rotating.
- For more than 5 seconds press simultaneously STOP and UP buttons,
until the motor jogs.
The motor is now in programming mode for only 10 seconds, the
motor is factory set at the medium level.
3- To increase the closing force, press the Up button until the awning
makes a slow movement, the cassette awning's closing force has moved
up a level.
To decrease the closing force, press the Down button until the store makes
a slow movement, the cassette awning's closing force has moved down
a level.
4- Confirm the new setting by pressing 2 seconds the STOP button, until
the motor jogs. The new setting is memorized.
4/6
a-
1
2
PROG ≥ 3s.
b-
1
2
PROG ≤ 1s.
1-
2-
+
0,5s. 5s.
3-
4-
2s.