ABB TB82PH Serie Instructions D'opération page 2

TB82PH ATEX Product Instruction Manual
CONTENTS
Section
CONTENTS.......................................................................2
USE OF INSTRUCTIONS .................................................2
INTRODUCTION...............................................................3
PRODUCT IDENTIFICATION ...........................................3
EUROPEAN ATEX DIRECTIVE INFORMATION..............4
TRANSMITTER MOUNTING DETAILS.............................9
ELECTRICAL CONNECTIONS - Power Wiring ..............10
SENSOR CONNECTIONS – Model TB5 & TBX5
Sensor Connections ....................................................11
OPERATING PROCEDURES .........................................13
Commissioning the Instrument ..................................13
Flow Chart For Basic Operation Mode.......................14
CONFIGURE MODE .......................................................15
Flow Chart For Advanced Mode ................................17
CALIBRATE MODE.........................................................18
OUTPUT/HOLD MODE ...................................................18
SECURITY MODE ..........................................................19
SECONDARY DISPLAY MODE......................................19
MAINTENANCE ..............................................................19
DISMANTLING AND RE-ASSEMBLY .............................20
SPECIFICATIONS ..........................................................21
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
1. The relevant sections of these instructions must be read carefully before proceeding.
2. Warning labels on containers and packages must be observed.
3. Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel and in
accordance with the information given.
4. Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in
conditions of high pressure and/or temperature.
5. Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry. Normal
safe handling procedures must be used.
6. When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard data sheets
(where applicable) may be obtained from the Company address on the back cover, together with servicing and
spares information.
2
USE OF INSTRUCTIONS
Page
Warning.
An instruction that draws attention to the
risk of injury or death.
Caution.
An instruction that draws attention to the
risk of damage to the product, process or
surroundings.
Note.
Clarification of an instruction or additional
information.
Information.
Further reference
information or technical details.
Although Warning hazards are related to personal injury,
and Caution hazards are associated with equipment or
property damage, it must be understood that operation of
damaged equipment could, under certain operational
conditions, result
performance leading
Therefore, comply fully with all Warning and Caution
notices.
Information in this manual is intended only to assist our
customers in the efficient operation of our equipment. Use
of this manual for any other purpose is specifically
prohibited and its contents are not to be reproduced in full
or part without
Communications Department, ABB Inc.
for more detailed
in degraded process
to personal injury or
prior approval of Technical
TB82PH-ATEX-EN-B
ABB
system
death.