Cleaning And Maintenance - EUROM Orsa Manuel D'utilisation

 Check whether switch 1 is set to OFF (O depressed)
 Connect the plug to an earthed power outlet.
 Turn the thermostat dial to maximum (clockwise as far as possible).
 Press switch 1 and, depending on what you want, switches 2 and 3 to start using the
heater.
 Once the desired temperature is reached, turn the thermostat dial back slowly until
you hear a click. The temperature is now set. The heater will automatically switch on
and off to maintain the set temperature. To set a higher or lower temperature, turn
the thermostat dial either clockwise or anticlockwise.
 Switch off the heater by resetting all switches to the OFF position. Remove the plug
from the power outlet; do this whenever the heater is not in use!
Safeguards
The Orsa Fireplace atmospheric fireplace is equipped with an overheating safeguard. The
overheating safeguard switches the heater off if it overheats internally. This may occur if
the heater cannot give off enough heat or if it cannot draw in enough fresh air. As
mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar.
If this happens, turn the fireplace off by switching the main switch to O and remove the
plug from the socket. Leave the fireplace to cool down for at least 15 minutes and remove
the cause of overheating. You can then switch the fireplace back on.
If the device overheats again or you cannot ascertain the reason for this, take the fireplace
to your service point to be checked/repaired.
Important! For safety reasons the fire will not automatically restart after overheating.
Check whether conditions are safe before switching it on! So never switch on the heater
by means of a timer and never connect it to a power supply that regularly switches on and
off.

Cleaning and maintenance

Always remove the plug from the socket and let the fireplace cool down before cleaning or
touching.
The Orsa Fireplace atmospheric fireplace does not need much maintenance. Always keep
the in- and outlet openings clean and dust-free. Use a soft cloth or a soft brush to clean
the outside of the metal case. Do not use abrasive cleaning fluids or special glass cleaners!
The fireplace contains no parts which need to be replaced by the user. If the device
malfunctions, immediately remove the plug from the socket and take to a service point.
Do not carry out repairs yourself and always ask for original parts to be used.
If the fireplace is to be stored after the winter period, clean it, pack it in original packaging
if possible and store in a cool, dry and clean place. Make sure the fireplace is kept upright.
32