Cleaning And Maintenance - EUROM Malmo Manuel D'utilisation

ATTENTION! If you want the stove to operate according to a timer
programme, it will not only have to remain on stand-by, but also switched
on (using the ON/OFF button). If this is not necessary, always switch off
the stove using the ON/OFF button, switch off the main switch and remove
the plug from the socket.
Switching off
If you are not using the stove, you must switch it off using the main switch (you
press O) and remove the plug from the socket. Doing this will erases all the
settings, also day and time. Only the timer settings are stored.
Protection
The Malmo atmospheric fireplace is equipped with an overheating protection.
The overheating protection switches the heater off if it overheats internally. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the
heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar.
If this happens, turn the fireplace off by switching the main switch to O and remove
the plug from the socket. Leave the fireplace to cool down for at least 15 minutes
and remove the cause of overheating. You can then switch the fireplace back on.
If the device overheats again or you cannot ascertain the reason for this, take the
fireplace to your service point to be checked/repaired.
Important! For safety reasons the fire will not automatically restart after
overheating. Check whether conditions are safe before switching it on! So never
switch on the heater by means of a timer and never connect it to a power supply
that regularly switches on and off.

Cleaning and maintenance

Always remove the plug from the socket and let the fireplace cool down before
cleaning or touching. The Malmo atmospheric fireplace does not need much
maintenance. Always keep the in- and outlet openings clean and dust-free. Use a
soft cloth or a soft brush to clean the outside of the metal case. The glass plate can
also be cleaned with a soft cloth. Do not use abrasive cleaning fluids or special
glass cleaners! If the device malfunctions, immediately remove the plug from the
socket and take to a service point. Do not carry out repairs yourself and always ask
for original parts to be used. If the fireplace is to be stored after the winter period,
clean it, pack it in original packaging if possible and store in a cool, dry and clean
place. Make sure the fireplace is kept upright.
41