ResMed AutoSet CS 2 Mode D'emploi page 40

CAUTION
!
•
•
•
P
ERIODICALLY
1. The mask and air tubing are subject to normal wear and tear. Inspect them
2. Open the power cord locking clip and remove the cord. Clean the exterior of the
3. Inspect the air filter to check if it is blocked by dirt or contains holes. See full
WARNING
!
Beware of electric shock. Do not immerse the flow generator or power cord in
water. Always unplug the flow generator before cleaning and be sure that it is dry
before reconnecting.
CAUTION
!
Do not attempt to open the A
inside. Repairs and internal servicing should only be performed by an authorised
service agent.
A F
IR ILTER
Inspect the air filter every month and check if it is blocked by dirt or contains holes.
The filter should be replaced every 6 months, or more often if the flow generator is
operating in a dusty environment.
36
Get user manuals: See SafeManuals.com
Do not use bleach, chlorine-, alcohol- or aromatic-based solutions (including all
scented oils), moisturising or antibacterial soaps to clean the cushion, mask, air
tubing or the A
S
UTO ET
the life of the product.
Do not wash or dry the mask frame at a temperature above 80
Exposure to higher temperatures may reduce the life of the product.
Do not hang the air tubing and pressure sensor tube in direct sunlight as the
tubing may harden over time and eventually crack.
regularly for damage.
flow generator with a damp cloth and mild detergent.
instructions below.
CS2. These solutions may cause hardening and reduce
CS2. There are no user serviceable parts
S
UTO ET
Air filter cover
o o
C (176 F).