ResMed AutoSet CS 2 Mode D'emploi page 39

C
LEANING AND
You should regularly carry out the cleaning and maintenance described in this manual.
CAUTION
!
Do not wash the pressure sensor tube. If fluid enters the pressure sensor tube allow
it to dry completely by hanging it in a clean place out of direct sunlight. If the
pressure sensor tube cannot be dried completely it should be replaced.
D
AILY
1. Disconnect the air tubing and pressure sensor tube and hang them in a clean, dry
2. Clean the mask according to the mask user instructions.
3. If you are using a humidifier, clean it according to the instructions in the manual.
W
EEKLY
1. Remove the air tubing and pressure sensor tube from the A
2. Remove the pressure sensor tube and Proximal cuff from the air tubing.
3. Wash the mask system according to the instructions supplied with it.
4. Wash the air tubing and Proximal cuff in warm water using mild detergent. Rinse
5. Before next use, assemble the mask and headgear according to the mask user
6. Reconnect the pressure sensor tube to the air tubing, then connect both to the
Figure 20: Undoing the air tubing assembly for cleaning
Get user manuals: See SafeManuals.com
M
AINTENANCE
place until next use. Do not hang the air tubing in direct sunlight as it may harden
and crack over time.
the mask.
thoroughly, hang and allow to dry.
instructions.
Proximal cuff. Attach the Proximal cuff to the mask.
Air tubing
Remove the pressure sensor tube
from air tubing
Remove Proximal cuff
Tubing clips
C
LEANING AND
CS2 unit and
S
UTO ET
M
AINTENANCE
35