ResMed AutoSet CS 2 Mode D'emploi page 21

CAUTION
!
•
•
•
•
R L
ES INK
The R
therapy. The card can be returned to your clinician so that they can observe your
progress and adjust flow generator parameters if necessary. The R
the back of A
to the ResLink User's Manual.
A -
NTI BACTERIAL
Your clinician may recommend that you use an anti-bacterial filter. A filter should be
placed in the air tubing between the mask and the flow generator. If using a humidifier,
place the filter between it and the flow generator (see Figure 10 below).
Typically, the filter should be replaced daily. Check the filter instructions for full details.
Whenever a filter is added, removed or replaced you must run the Air Circuit Learn
function (see "Learn Circuit" on page 26).
Only hydrophobic anti-bacterial filters should be used with a
N
OTE
Get user manuals: See SafeManuals.com
Be very careful not to allow water to enter the A
could affect therapy and/or damage the device.
Do not tip the H
UMID
If water enters the A
UTO
back of the unit and unplug it from the power outlet. Return the unit to your
equipment supplier for checking.
Set up the H and the A
A
UMID IRE
runs higher than the machines. This will prevent condensation build-up.
If condensation appears in the mask, turn the humidifier settings down.
™
™ is a device that records data onto a SmartMedia™ card during your
L
ES INK
CS2 as shown. For full details on using the R
S
UTO ET
F
ILTER
A while it is connected to the A
IRE
CS2 device, turn off the main power switch at the
S
ET
CS2 unit so that the tubing to the mask
S
UTO ET
S CS2 as this
UTO ET
S
UTO ET
connects to
L
ES INK
, please refer
L
ES INK
or
H A 2i H
UMID IRE UMID
T A S CS2 S
HE UTO ET YSTEM
CS2.
C.
A 2i
IRE
17