American Standard Cadet A5350110020 Instructions D'installation page 3

INSTALLATION #2 - TOP MOUNT WITH RUBBER PLUG
Side view of the toilet seat installation parts.
Hinge
Cap
Adjustment
Washer
Hinge
Base
Hinge
Gasket
Rubber
Plug
Stainless
Steel Bolt
3
Unscrew and
remove bolts
Once plug is in place,
unscrew and remove bolts
and keep nearby for step 6.
5
Insert the plastic adjustment washers
with flat surface facing up.
7
Once properly positioned, tighten
the bolts with your wrench.
1
PLUG
Flange
Bulb
For ease of installation of black
rubber plugs, insert steel bolt
(capture a few threads) and wet
the lower area with some water
(soapy water works best).
4
Slot Alignment
Under Hinge
Base
Attach Hinge Gaskets to bottom of Hinge Base.
Make sure Alignment Tabs on Hinge Gaskets
match the slots under the Hinge Base.
6
Adjustment
Washer
Hinge Base
8
Page 2
2
Bolt
Wet this area
with water
Tab
Hinge
Gasket
When the seat is properly aligned with the front edge of the bowl,
slip the bolt through the washer and the bowl bolt holes.
The hinge cap covers are designed to
snap lock on to the hinge. Position the
hinge covers and push down on the cover.
Push ONLY until
bulb goes through
Push down
together
NOTE: FLANGE MUST REMAIN
ABOVE THE SURFACE.
DO NOT ALLOW PLUG TO FALL
THROUGH!
Align hinges over holes on toilet bowl.
7302106-100 Rev. D 7/15