Télécharger Imprimer la page

American Standard Cadet A5350110020 Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION #1 - BOTTOM MOUNT WITH PLASTIC WINGNUT
Side view of the toilet seat installation parts.
Hinge
Cover
Plastic
Bolt
Adjustment
Washer
Hinge
Gasket
2
The installation kit includes two
sets of stainless washers:
2 with center holes and 2 with
offset holes.
The offset washers hole can be
set forward or back allowing the
seat to be moved back from or to
the forward edge of the bowl rim.
To Move
Seat Forward
FRONT OF BOWL
4
With the plastic bolts installed, thread the
winged plastic nuts on to the bolts.
1
Hinge
Under Hinge
Base
Attach Hinge Gaskets to bottom of Hinge Base.
Plastic
Make sure Alignment Tabs on Hinge Gaskets
Wing Nut
match the slots under the Hinge Base.
TANK
To Move
Seat Back
5
Tighten the bolts using a screwdriver.
Slot Alignment
Tab
Hinge
Gasket
3
Page 1
Align hinges over holes on toilet bowl.
When the seat is properly
aligned with the front edge
of the bowl shlip the bolt
through the washer and the
bowl bolt holes.
6
The hinge cap covers are designed to snap
lock on to the hinge. Position the hinge
covers and push down on the cover.
7302106-100 Rev. D 7/15

Publicité

loading