Bernard Controls AQ Logic RANGE Instructions De Mise En Service page 7

All manuals and user guides at all-guides.com
3 ACTUATOR INSTALLATION
3.1 Fastening actuator on the valve
Actuator should be secured directly to the
valve using proper bolts or via a proper
interface.
After assembly, the actuator can operate in
any position.
You can modify your display orientation in order to keep normal

reading orientation.
 To set your display orientation, see §0.
However:
•
do not handle the actuator by handwheel to avoid damage on

actuator gearing
•
cable glands must not be oriented upwards (loss of water
tightness)
3.2 Opening the control compartment
You need to open the control compartment and remove the cover in
order to wire actuator. If closing direction is not standard (clockwise),
and it is not already done, change the orientation of the position
indicator cap.
How to remove the cover
1. With 10mm angled socket
wrench
screwdriver, untighten the 4
screws.
2. Raise the cover then unplug it
from the board.
English
or flat blade
7
7