Grammer PRIMO XM PLUS Mode D'emploi page 18

Safety instructions
The driver's seat is not watertight and must be protected against splashes of water!

Any conversion or refitting work on a GRAMMER AG driver's seat must be performed ex-

clusively in authorized workshops by trained or suitably qualified personnel and in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
Improper installation and assembly bear the risk of bodily injury or property damage

and the proper function of the driver's seat or mounted parts can no longer be guaranteed.
Before driving, you must check if all seat settings selected guarantee a safe operation

of the vehicle.
Seat tested and approved in accordance with GRAMMER standard (GN 009, GN 010, GN

011, depending on development date) from 50 kg to 130 kg.
Connecting data
If you need to connect cables to the vehicle supply network, strictly observe the following

instructions:
Before you connect an electrical consumer fitted in the driver's seat (e. g. the seat
heater or the seat ventilation), you must obtain the relevant electrical data for the respec-
tive vehicle with reference to voltage, protection and the kind of connections from the man-
ufacturer, from GRAMMER AG or the company's agencies.
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
12V DC
24V DC
For building an electric connection, select an electric circuit by means of which the electric
consumers of the driver's seat are separated from the live network when the ignition is
switched off.
18
Seat switch – Current carrying capacity
10A Switch model:
4A Switching power:
Max. switching current:
None of these parameters must be exceeded, not
even for a short term.
No inductive load admissible!
change-over contact
5W
0,5A
GB