Polygroup SUMMER WAVES ELITE Manuel De L'utilisateur page 9

Horizontal Beam with Easy Link T-Fitting Set
2
Figure 2
8. Insert the Vertical Legs 3 into the Leg Caps 6
(see Figure 3).
3
6
10a. Slide a set of Horizontal Beam with T-Fitting into one sleeve of the liner (see Figure 5).
Note: 1. Leave the set with Easy Link T-Fitting to be installed LAST.
2. Make sure the vertical part of the T-Fitting faces down and away from the liner to avoid puncturing the liner.
b. Slide the next set of HorizontalBeam with T-Fitting into the sleeve beside the first set (see Figure 6).
Then, link the open end of the horizontal beam with the T-Fitting of the first set.
Press the push-button while sliding the parts together. Release the push-button for the parts to snap into place and lock tight.
5
9a. Lay the pool liner on the ground (see Figure 4).
Note: Ensure the pool is between 10 to 21 feet away from any electrical outlets.
b. Place the connected parts around the pool liner, one set by one set near each
top sleeve.
Figure 3
Figure 5
OWNER'S MANUAL
3
6
10' - 21'
305 - 640 cm
1
2
4
Figure 4
* Image for reference only
Figure 6
9