Polygroup SUMMER WAVES ELITE Manuel De L'utilisateur page 11

IMPORTANT: BEFORE ADDING WATER TO YOUR POOL YOU MUST INSTALL THE POOL WALL
FITTINGS OR ENTIRE FILTRATION SYSTEM FIRST. BEFORE ADDING WATER TO YOUR POOL
FOLLOW THE INSTRUCTIONS BELOW.
If your pool included openings or you are going to purchase a filter pump system, position the Suction & Return fitting locations so they are 10 to 21 feet
from the electrical outlet you plan to use for the pool pump.
If your pool came with Fittings - Install both the Suction and Return fittings to the pool wall before filling the pool.
For USA only
Pool exterior
Water Cap Suction Fitting Gasket Thrust Washer
Split Suction Fitting Lock Nut
SFX SKIMMERPLUS FILTER PUMP
Pool
exterior
Pool interior
SUCTION FITTING
RX CARTRIDGE FILTER PUMP
Pool
interior
or
Lock Nut Seal Ring
Solo Suction Fitting Lock Nut
SUCTION FITTING
Pool
exterior
Pool interior
Return Fitting
Diverter
Service Plug Gasket RF Nut
Locking Ring Return Fitting Suction Fitting
Washer
RETURN FITTING
Pool interior
Pool exterior
Lock Nut Seal Ring
Water Cap Suction Fitting Gasket Thrust Washer
Solo Suction Fitting Lock Nut
NOTE: For Sand Filter Pump / Cartridge Filter Pump
CP2000-C, please follow the Sand Filter Pump /
Cartridge Filter Pump CP2000-C owner's manual to set up
the fitting. Please check the water pump's instruction manual
for more instructions.
Please Note: The Black Rubber gasket (Gasket) should always be slid over
the threaded plastic suction or return fitting and be on the inside before the
fitting is placed through the pool wall to make a watertight connection.
Make sure to put on both the Water Cap and the Service Plug while you fill
your pool, or until you are ready to add a filtration system.
90° Elbow
OWNER'S MANUAL
Pool interior
Service Plug Return Fitting
RETURN FITTING
Pool exterior
Gasket Fitting Lock
Nut
11