cecotec CONGA 5290 ULTRA Manuel D'instructions page 40

ENGLISH
6. CLEANING AND MAINTENANCE
Jalisco main brush
− Turn the robot around and press the main brush's release button to take the cover out.
− Take the main brush out and clean the compartment.
− Clean the main brush with the provided tools and use water and soap if necessary. Dry it
carefully before installing it again. The brush must be completely dry before installing it, as
any remaining moisture can reach the motor and damage it. Fig. 9-10.
− Place the main brush in its position and fasten the cover clip.
Recommendation
Replace the main brush every 6-12 months to ensure efficient operating (depending on the
frequency and type of use).
Wet & dry tank
Fig. 11.
− Remove the solids tank.
− Open the tank cover and empty it.
− Remove the filter and filter holder as shown in the image.
− Use the cleaning brush to clean the inside of the solids tank.
− You can clean the dust compartment with water, without immersing the tank.
− Install the dust tank back in the robot.
High-efficiency filter
Fig. 12.
Remove the high-efficiency filter and shake it to remove all the dust.
Note:
− Replace the high-efficiency filter every 3 months depending on the frequency and type of
use.
− Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
Side brush
Fig. 13.
Remove it with a torx screwdriver and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Free-fall sensors
Fig. 14.
40